Author Topic: Shadows still overlap planes (Read 790 times)

mjolnir · « **on:** November 16, 2003, 11:29:31 AM »

Still seeing my shadow on top of my plane instead of underneath it. Also, is anyone else noticing that the rolling tendencies are getting worse, to a point that it's almost impossible to takeoff because the planes roll over part way down the runway (even the goon)?

Kaz · « **Reply #1 on:** November 16, 2003, 01:03:08 PM »

I don't have any problems in any of the planes using auto-take off or manually. What kind of rolling are you experiencing?

BenDover · « **Reply #2 on:** November 16, 2003, 04:17:54 PM »

Dynamic shadows only work on the p51 and spit

hitech · « **Reply #3 on:** November 16, 2003, 04:35:25 PM »

A few ati cards have this problem, looking for a solution to it.

HiTech

WhiteHawk · « **Reply #4 on:** November 17, 2003, 08:01:20 AM »

yea..me too. I posted in the bug report.

Sarge1 · « **Reply #5 on:** November 24, 2003, 11:12:36 AM »

in CM eye Mode i notice that when above the planes at fields the trees and hills go over top p51's, FR's have dropped by 50% but less vid mem is used CM Eye Frame rate 2.5 above grouns is about 8 and all other tests are 14 to 12 v0-v3

Time of this report: 11/24/2003, 12:03:19

Operating System: Windows XP Home Edition (5.1, Build 2600) Service Pack 1 (2600.xpsp2.030422-1633)
System Manufacturer: D850GB
System Model: GB85010A
BIOS: Default System BIOS
Processor: Intel(R) Pentium(R) 4 CPU 1300MHz 423 pin socket
F.bus 400
Memory: 384MB RAM
Page File: 110MB used, 811MB available
DirectX Version: DirectX 9.0b (4.09.0000.0902)
DxDiag Version: 5.03.0001.0902 32bit Unicode

Card name:

RADEON 8500 SERIES
Manufacturer: ATI Technologies Inc.
Chip type: RADEON 8500 AGP (0x514C)
DAC type: Internal DAC(350MHz)
Display Memory: 64.0 MB
Current Mode: 1024 x 768 (32 bit) (60Hz)
Driver Name: ati2dvag.dll
Driver Version: 6.14.0010.6387 (English)
DDI Version: 9 (or higher)
Driver Attributes: Final Retail
Driver Date/Size: 9/12/2003 18:43:24, 372736 bytes

Sarge1 · « **Reply #6 on:** November 25, 2003, 09:54:41 AM »

also was checking on different runways and find that the runways on clip board do not face same direction as when your on the runway. I launched on SW runway from clip board was facing W on map. some on clip board were showing N | S directions on CB map and landing i was facing SW / NW

Sarge1 · « **Reply #7 on:** December 03, 2003, 09:31:07 AM »

if you fly around mountains i can see like shadows of the tree tops on other side of mountain following me and when i reach the other side see the trees that the shadows represent........... no bullets sprite hits when firing at buildings, seem to go straight thru
.............