Author Topic: please help (Read 309 times)

giorgaras · « **on:** April 14, 2004, 01:00:50 AM »

when i press the - and = buttons ,nothing happens.It doesnt slow or raise the speed of the plane.Instead of this when i start the engine (e), the plane gets full throttle of its own. I checked the keymap but nothings wrong..I cannot slow down the speed so i cant land.
I use windows me

Skuzzy · « **Reply #1 on:** April 14, 2004, 07:00:31 AM »

If you have auto-takeoff enabled, then the engine will go full throttle on take-off. Check the flight settings in the clipboard as auto-takeoff is enabled by default.

maddog · « **Reply #2 on:** April 14, 2004, 09:50:19 AM »

throttle isn't effected by auto takeoff.. Functions whether auto take off on or not... Has to be either mapping or calibration......

Skuzzy · « **Reply #3 on:** April 14, 2004, 11:02:31 AM »

Oh duh, my bad. I was addressing his concern about the throttle going to full speed when he started his engine.

You might just try renaming the "settings" folder in the Aces High in the installation directory, which allows Aces High to start as if it were a fresh installation.

giorgaras · « **Reply #4 on:** April 15, 2004, 03:04:45 AM »

thank you very much for your help. I tried various things and finally i figured the solution by myself.
Actually the speed handling is set by default at the mouse wheel.I didnt know it and when i started the engine, the default wheel position is full throttle.So all you have to do is to move a little up and down the wheel.Thats all.I hope i helped some people with the same problem.Also you can turn of this mouse wheel setting at the calibration.