« previous next »
Pages: [1]   Go Down

Author Topic: Stiffening up the X52  (Read 225 times)

Offline Tilt

  • Platinum Member
  • ******
  • Posts: 7357
      • FullTilt
Stiffening up the X52
« on: August 18, 2005, 10:59:52 AM »
I just put a rubber washer in the cavity where the upper side of the spring locates. A large tap washer will do.

This pre compresses the spring and makes it a bit stiffer.

Spring feed back at the end of travel is a bit more noticable now.
Logged
Ludere Vincere

Offline humble

  • Platinum Member
  • ******
  • Posts: 6434
Stiffening up the X52
« Reply #1 on: August 18, 2005, 05:12:03 PM »
Hmmm....

Do you have to take it apart or did you cut the washer and pop it on that way????
Logged

"The beauty of the second amendment is that it will not be needed until they try to take it."-Pres. Thomas Jefferson

Offline Tilt

  • Platinum Member
  • ******
  • Posts: 7357
      • FullTilt
Stiffening up the X52
« Reply #2 on: August 18, 2005, 05:34:37 PM »
I cut the washer......the spring holds it in place............ its easily  reversable
Logged
Ludere Vincere
Pages: [1]   Go Up
« previous next »