same problem

[RafBader]

I'm having the same problem. Just bought a new X45 and chpro pedals. When i try to set up the rudder it controls the wrong axis in game. The stickset will set up ok with the toggle switch on the throttle yoke but if i try to det the peddles it works the roll controls only (left and right ailerons). Have'nt played in a couple of months because of this problem. If someone out there has a program for this setup that works please post it . I would play with just the rocker switch, but my stubby little ken doll hands make this a total pain in the arse.
 Thanks,
RafBader

[JB73]

delet jstick.cfg in the AH settings folder

start up the game and assign the axis from scratch. make sure both sticks (CH and x45) are calibrated and recognized outside of the game first too

[Eagler]

In my setup I have the rocker programmed as aileron trim in the saitek software then in AH in the joystick settings, I choose rudder-CH pro peds- then Z axis ( i think its Z - at work now, have to check when I get home)

before I choose th rudder input, I select the X45 and set all the controls to it, then choose rudder and ch pro peds

hope this helps

[Eagler]

yep, Z axis = rudder

also for whatever reason I have to set roll to its axis as it does not do it auto some of the time

gl

[Skuzzy]

Pressing the "Set All Inputs" and pressing "OK", should reset Aces High to defaults for whatever stick is plugged in (i.e. basic programming).