Author Topic: AH not saving views... (Read 374 times)

aztec · « **on:** December 29, 2004, 06:52:51 PM »

since the release of 2.0. Strange thing is that it mostly affects the side views but can affect them all in some planes. Any help would be greatly appreciated, thx, aztec.

WMLute · « **Reply #1 on:** December 29, 2004, 07:08:19 PM »

noticed this as well.... I'm usually loosing my "UP" views i.e. back up, forward up. etc.

aztec · « **Reply #2 on:** January 17, 2005, 06:04:38 AM »

Ok, been quite awhile since I posted this problem....does HTC monitor this forum? Sure would like some help as the future of my account hinges on getting this resolved. Thank you very much in advance!

Skuzzy · « **Reply #3 on:** January 17, 2005, 06:46:10 AM »

Is it only happening on certain planes, or all of them?

Are you running an anti-virus program while playing AH? This can cause it too (getting to where I despise AV programs).

aztec · « **Reply #4 on:** January 17, 2005, 09:39:06 AM »

Thx for thre quick reply Skuzzy.

It happens on all planes however not the same views are always affected from plane to plane. The most common view affected is the straight 3 and 9oc. It can be as few as these or all the views depending on the plane. I have to reset my views for every hop and it does get frustrating!

I am running Norton AV...will go and try without it right now.
Once again thx Skuzzy and I'll post my results in a few minutes.

aztec · « **Reply #5 on:** January 17, 2005, 09:49:30 AM »

Just tried w/NAV turned off...same results Skuzzy.

Skuzzy · « **Reply #6 on:** January 17, 2005, 11:01:47 AM »

Move or rename the Aces High "settings" folder and try it offline. If you have been playing Aces High with your AV on, then wierd results can happen and get saved in those files.

zmeg · « **Reply #7 on:** January 17, 2005, 12:11:42 PM »

Make sure your settings folder isn't set to read only.

WMLute · « **Reply #8 on:** January 17, 2005, 02:37:19 PM »

Quote

Originally posted by zmeg
Make sure your settings folder isn't set to read only.

good advice. check the files and C if they R READ ONLY. (right click, choose PROPERTIES) if they ARE r/o, then uncheck that box.

aztec · « **Reply #9 on:** January 17, 2005, 04:00:15 PM »

Score!!!!!:) All files were read only...thx zmeg, Lute and Skuzzy, this has been driving me nuts for weeks. <~~>! aztec~~

Skuzzy · « **Reply #10 on:** January 17, 2005, 04:02:19 PM »

Oh,..let me guess. You copied the files from a CD?

aztec · « **Reply #11 on:** January 17, 2005, 07:55:11 PM »

Nope..just DL the updates. I had forgotten but after the 2.0 update AH would'nt remember my login info. Can't remember if it was you or Doug I talked with on the phone ....as it turns out that was a read only prob as well. Guess that will be the 1st place I look if any similar probs crop up. Thx again for the assist Skuzzy, .