Author Topic: CH HOTAS Setup Problems  (Read 294 times)

Offline Rick Opp

  • Zinc Member
  • *
  • Posts: 11
CH HOTAS Setup Problems
« on: September 14, 2005, 10:18:28 PM »
I have CH USB Combat stick, pro throttle, and pro petals.

I had them set up in AH OK before I switched computers.

I just got a new kick bellybutton gaming computer and I am having trouble setting up again.

I can see all 3 controllers in the AH stick mapping screen.  The throttle is the only one that any changes show up on when I move the throttle.  The stick and petals seem to be dead.  None of the numbers change or buttons light when actuating the controls for the stick or the petals.

they all show up but only 1 registers changes.   ????

I am running them direct without the CH control manager

Any Ideas?

Thanks
RDO310

:huh

Offline Rick Opp

  • Zinc Member
  • *
  • Posts: 11
CH HOTAS Setup Problems
« Reply #1 on: September 14, 2005, 10:26:20 PM »
BTW

When I plug in the 3 controllers 1 at a time they work.

When all 3 are plugged in at the same time only 1 works, usually the throttle.

???

RDO310

Offline FOGOLD

  • Silver Member
  • ****
  • Posts: 1886
CH HOTAS Setup Problems
« Reply #2 on: September 15, 2005, 02:18:40 AM »
I forget how this goes, but I think you have to highlight the controller you want, then "set controller" . You have to "activate" each controller. AH set up for controllers has had me foxed more than once, but I think that is how you do it.

Offline Delirium

  • Platinum Member
  • ******
  • Posts: 7276
CH HOTAS Setup Problems
« Reply #3 on: September 15, 2005, 03:08:15 AM »
FOGOLD is exactly right... AH won't start reading inputs on a controller until it is assigned to a flight control.

Just make sure you assign the joysticks in direct/unmapped mode or you won't be able to tell the difference between them as they will be called 'CM Device 1' instead of 'CH Prothrottle'.
Delirium
80th "Headhunters"
Retired AH Trainer (but still teach the P38 selectively)

I found an air leak in my inflatable sheep and plugged the hole! Honest!

Offline Balsy

  • Nickel Member
  • ***
  • Posts: 717
CH HOTAS Setup Problems
« Reply #4 on: September 15, 2005, 08:24:40 AM »
Hit the "set all inputs buttton" in Ah... I think that does the trick.

Offline Rick Opp

  • Zinc Member
  • *
  • Posts: 11
That Did It
« Reply #5 on: September 15, 2005, 10:13:43 AM »
Setting the inputs did it.  Thanks.

It had been so long since I set it up the first time that I forgot.

A note to that effect on the setup screen would be usefull and save senile people like me a lot of heartache.

Later
RDO310