Author Topic: boot.ini question (Read 231 times)

Krusty · « **on:** May 08, 2007, 10:50:03 AM »

I ran the patch and did the registry change as outlined in Skuzzy's locked thread in the tech support forum. I just went from an old CPU to a Conroe core.

RedTop posted his specs, and Odee or TexVA or somebody mentioned he should have a line in his boot.ini and was mentioning the /usepmtimer line, but I noticed something else in there.

"/numproc=2" was also on the same line.

I tried it out. I didn't get any BSDs but didn't notice anything good either.. What does this do? My first intuition is that it specifies to the OS that there are 2 processors instead of just 1.

Is that automatic, and should I remove this option from my boot.ini?

Kev367th · « **Reply #1 on:** May 08, 2007, 01:32:27 PM »

Number of processors is set by the Windows HAL.

Single CPU HAL = ACPI Uniprocessor PC
Multiple cores/CPU HAL = ACPI Multiprocessor PC

You can check the HAL used from the device manager under the "Computer" entry.

Sundowner · « **Reply #2 on:** May 08, 2007, 07:47:30 PM »

Found this for ya, Krusty.

/NUMPROC=

Specifies the number of CPUs that can be used on a multiprocessor system. Example: /NUMPROC=2 on a four-way system will prevent Windows from using two of the four processors.

http://www.microsoft.com/technet/sysinternals/information/bootini.mspx

Good luck,
Sun

Krusty · « **Reply #3 on:** May 08, 2007, 08:54:46 PM »

Well my HAL is listed as "multiprocessor" under the device manager where Kev said, and Sun found the general description of it... I'm going to leave it in place.

Fulmar · « **Reply #4 on:** May 08, 2007, 09:09:30 PM »

Sundowner · « **Reply #5 on:** May 08, 2007, 09:20:06 PM »

Quote

Originally posted by Fulmar

[on Dave's return to the ship, after HAL has killed the rest of the crew]
HAL: Look Dave, I can see you're really upset about this. I honestly think you ought to sit down calmly, take a stress pill, and think things over.

Regards,
Sun