Author Topic: "dont move your controls so rapidly"  (Read 279 times)

Offline -ammo-

  • Platinum Member
  • ******
  • Posts: 5124
"dont move your controls so rapidly"
« on: March 04, 2001, 03:50:00 PM »
I get this all the time, never before have I. My flying style has not changed either. Am I the only one?? has there been a change in the code making it sensitive? Is it just my stick? I dont stickstir.

<S> ammo
Commanding Officer, 56 Fighter Group
Retired USAF - 1988 - 2011

Offline Vermillion

  • Platinum Member
  • ******
  • Posts: 4012
"dont move your controls so rapidly"
« Reply #1 on: March 04, 2001, 04:31:00 PM »
Most likely you are getting stick spikes.

------------------
Vermillion
**MOL**, Men of Leisure

TheWobble

  • Guest
"dont move your controls so rapidly"
« Reply #2 on: March 04, 2001, 06:15:00 PM »
clean yer pots....or try some better pot..or maby see if yer pot is bad.

Offline jihad

  • Nickel Member
  • ***
  • Posts: 356
"dont move your controls so rapidly"
« Reply #3 on: March 04, 2001, 06:20:00 PM »
 I got the same message after I switched to a F-16 Combatstick, I had to add damping which made the planes sluggish.

I also lose calibration a lot since switching, I'm pretty sure its the lousy gameport on the SBLive card as it spikes badly when I run a diagnostic on it.

Offline VoX

  • Copper Member
  • **
  • Posts: 344
"dont move your controls so rapidly"
« Reply #4 on: March 06, 2001, 04:40:00 AM »
I get it also, had to add a bit more damping.
I have a MS sidewinder FF, seems to have sorted it for the moset part but, it would appear that it is linked to the use of the HAT switch. Especially prevelent when in a turn using both rudder and aileron & looking to the side using the HAT.

U get used to it, pain in the arse in a dogfight tho  

Cheers VoX
Shoot! I smell Zack! Doom's a Fairy, Jimmy's a drunk, RT is very suspicious!
how do I start my engine...no seriously, How?

Offline Wardog

  • Copper Member
  • **
  • Posts: 206
"dont move your controls so rapidly"
« Reply #5 on: March 06, 2001, 12:36:00 PM »
I used to get that message, had to adjust Deadbands and dampening. Also anytime you install DX it enables Polling with Interups, ya need to disable it in Win Jstick setup..

Dog out.........

Offline BigMax

  • Gold Member
  • *****
  • Posts: 2427
      • http://www.cybrtyme.com/personal/hblair/mainpage.htm
"dont move your controls so rapidly"
« Reply #6 on: March 06, 2001, 06:22:00 PM »
Mine does it too... Will check my settings thanks...

Offline Dinger

  • Silver Member
  • ****
  • Posts: 1705
"dont move your controls so rapidly"
« Reply #7 on: March 06, 2001, 11:45:00 PM »
I get it when I fly a buff.  Switching between gunner positions means you gotta change your stick directions rapidly.  Add in a low-alt mission, and you've got a nasty death.