« previous next »
Pages: [1]   Go Down

Author Topic: Factory Surfaces (Buzzsaw)  (Read 401 times)

Offline Chalenge

  • Plutonium Member
  • *******
  • Posts: 15179
Factory Surfaces (Buzzsaw)
« on: October 05, 2016, 05:10:28 PM »
Every factory has a misaligned surface edge. I think that's what it is, because it runs all around the factories.

As indicated by the red lines:

Logged
If you like the Sick Puppy Custom Sound Pack the please consider contributing for future updates by sending a months dues to Hitech Creations for account "Chalenge." Every little bit helps.

Offline USCH

  • Silver Member
  • ****
  • Posts: 1713
Re: Factory Surfaces (Buzzsaw)
« Reply #1 on: October 05, 2016, 07:51:49 PM »
Also (buzzsaw) the ships do not respawn to the correct country when a port is taken.
Logged

Offline drfritz

  • Copper Member
  • **
  • Posts: 128
Re: Factory Surfaces (Buzzsaw)
« Reply #2 on: October 05, 2016, 07:57:27 PM »
that map need to be taken out of rotaion till the bugs are fixed. the all might bish reset it in less than 6 hours. didnt even get to see much of any of it.
Logged

Offline Chalenge

  • Plutonium Member
  • *******
  • Posts: 15179
Re: Factory Surfaces (Buzzsaw)
« Reply #3 on: October 06, 2016, 09:22:56 PM »
I understand that HiTech may have reset it because something wasn't working correctly.
Logged
If you like the Sick Puppy Custom Sound Pack the please consider contributing for future updates by sending a months dues to Hitech Creations for account "Chalenge." Every little bit helps.
Pages: [1]   Go Up
« previous next »