Author Topic: Can't get my brakes to work (Read 376 times)

maxtor · « **on:** January 06, 2003, 10:09:20 AM »

I can not get my wheel brakes to work. Not on keyboard or on stick. I have mapped and I have remapped both - for example the joystick. The mapper seems to function correctly (button indicates on mapper control panel when I press it) However when I go to use the function, no brakes.

All other functions map fine and normal (flaps, guns, etc etc etc.)

I am clueless - any suggestions?

(going to post this in technical support)

San · « **Reply #1 on:** January 06, 2003, 11:49:13 AM »

Check and make sure your throttle is calibrated correctly your brakes might be functioning but your throttle might not be all the way to idle.

snocone · « **Reply #2 on:** January 08, 2003, 12:01:30 PM »

make sure you are holding down the button, the brakes are not a toggle command, you must hold down on them, i mapped them to a switch on my throttle control instead off a button, that way i just turn the switch on and they stay on, hope this helps

bigsky · « **Reply #3 on:** January 10, 2003, 03:09:07 AM »

wheels must be on the ground to work. c and v are the ones i use for right and left wheel brakes or space for both at the same time.