Aces High Bulletin Board
General Forums => Hardware and Software => Topic started by: bike killa on June 30, 2000, 03:07:00 AM
-
here i go again
my config is:
A-Bit BH6
Celeron 366A
Savage3DBlaster4
SB128PCI
64Mb RAM
yesterday i was trying to set my bus speed to 78, 81, 75, or even 100Mhz, but it was auttomaticly switched to 66Mhz again or i swa message like CPU is unworkable, unstable or something like that...i was enable do do it before but now it didn't working (http://bbs.hitechcreations.com/smf/Smileys/default/frown.gif) someone have any idea what's going on? as i said i did it before and i was enable to load Winblows (hehe Windows worked only in 1st reboot (http://bbs.hitechcreations.com/smf/Smileys/default/wink.gif) but now i'm really surprised...maybe i missed something?
-
Sounds like the problem is the SPEED ERROR HOLD setting.
This option appears when you make overclocking changes in set-up.
It is "enabled" by default. Just disable it, and you should be good to go.
-
There's "Speed Error Hold" (or something like that) option in CPU SOFT MENU. Choose Disabled, then you can choose other FSB speeds that was processor is meant for.
Hope this helps...
<Meisseli>
-
Hi bike killa,
Celerons are supposed to run at 66MHz , i am surprised that it worked before.
Celi 400 oc to 450 MHZ here.
blitz