Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: Codeman on November 30, 2003, 04:11:39 AM

Title: Trouble using .dot commands to move.
Post by: Codeman on November 30, 2003, 04:11:39 AM

I try to move to a field using the .move command, but it says that I can't move to that field. Im on a big map, so I dont want to move the map around to move to that airfield, so how do I make the .move command work?!

Title: Re: Trouble using .dot commands to move.
Post by: Flossy on November 30, 2003, 04:43:03 AM

Quote

Originally posted by Codeman
I try to move to a field using the .move command, but it says that I can't move to that field. Im on a big map, so I dont want to move the map around to move to that airfield, so how do I make the .move command work?!

If you are getting a message that you can't move to that field, it is because you are trying to go to an enemy field.  If you try it with a definite friendly field, it will work.  Another way, if you know someone is at or up from a particular field, is to find them on the roster and click GOTO.  :)

Title: Trouble using .dot commands to move.
Post by: Codeman on November 30, 2003, 05:04:08 AM

Im not trying to move to an enemy field.  Its a definet friendly field.  I cant move to it with the .dot commands.

Title: Trouble using .dot commands to move.
Post by: Flossy on November 30, 2003, 05:56:13 AM

OK, must be syntax then..... command is .move ### - where ### is the number only of the field you want to go to.  If you include the initial letter (A, V, P or C) that could be why you get the error message.