Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Swager on December 05, 2003, 03:51:14 PM

Title: No Buttons On X45
Post by: Swager on December 05, 2003, 03:51:14 PM

My X45 calibrates fine and I have surface control.  None of my buttons work.  I did button mapping in AH.  The button check out OK in the Windows Game Controller area.

I just changed to Windows XP.

Any clues?

Thanks

Title: No Buttons On X45
Post by: San on December 05, 2003, 04:59:45 PM

In Aces high go to setup>Joystick>select joystick
 Click on the x45 and click the set all buttons tab at the bottom. Then map your buttons.

Title: No Buttons On X45
Post by: Swager on December 05, 2003, 05:55:41 PM

I've already done that and the movement works fine, just no buttons

Title: No Buttons On X45
Post by: Swager on December 05, 2003, 06:55:25 PM

OK I got most of it to work but when I started setting up the buttons in the AH JOYSTICK section the MODE switch on the throttle so everything is off by 3.  If I move the Mouse POV to the right (090) I highlights something different.  

This is getting tiring!  :(

Title: No Buttons On X45
Post by: Eagler on December 05, 2003, 10:55:30 PM

I use a profile built with the Saitek software for everything but the views and don't have a problem