Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: dracon on December 13, 2003, 12:14:50 AM

Title: CHPro USB Throttle needs cleaned! Help!
Post by: dracon on December 13, 2003, 12:14:50 AM

Thanks for looking.....

CH Pro throttle USB has suddenly started to not go full.  I have the CM installed and have calibrated it many times over the 3 years I have owned it.

I was able to get it going tonight by turning it upside down and sliding it back and forth.  I also used canned air  to try to clean it.

It works for now but I want to open it and clean the throttle slider.  How or Can do I do this?

I know I have to remove the rubber feet and unscrew the screws.  What do I d from there and what's the best method to clean it?

I ask......cuz I have taken other Joysticks apart and had wished I bought a Jig-Saw puzzle instead :)

Txs,

Title: CHPro USB Throttle needs cleaned! Help!
Post by: dracon on December 13, 2003, 12:59:45 PM

Ok... Never mind.  Bottom dropped right off after removing the 4 screws.  Compressed air on the pot waaalaaah!  She's workin!

Title: CHPro USB Throttle needs cleaned! Help!
Post by: Wanker on December 15, 2003, 07:56:40 AM

I'll have to remember that trick, glad you got it working again. :)