Aces High Bulletin Board
General Forums => Aces High General Discussion => Topic started by: MANDOBLE on May 23, 2001, 04:14:00 AM
-
A friend shared with me some useful tricks to do with the frontal view, especially useful for 190 pilots.
Most of us have 7,9,4,6,1,2 and 3 in keypad configured as normal "level" view, and these keys with 5 as looking up views. Well, you can configure much more frontal views using "extrange" key combinations. An example:
Press 7 and 1 at the same time, you'll have normal frontal view. Now, with these key pressed, change the POV with cursors and pgup/down and press F10 to save the pos. Now you have the normal frontal view and another frontal view with a different POV while pressing 7 and 1. You can repeat the operation with more unused key combinations (8 + 2, 9 + 3, etc) having, as result, a bunch of different frontal views.
In the 190 I have 7 + 1 view configured to look at the instrument pannel from a lower possition, this way I'm able to check engine overheat with a single key press.
The only problem is that you'll be able to configure only different frontal views, the trick doesnt work with rear views.
[This message has been edited by MANDOBLE (edited 05-23-2001).]
-
Then again, you could just remap the semi-colin (;) key to look forward-down so you can see all the insturments. That's what I did since I fly with one hand on the trim keys.
-----------------------
Flakbait [Delta6]
Delta Six's Flight School (http://www.worldaccessnet.com/~delta6)
Put the P-61B in Aces High
"With all due respect Chaplian, I don't think God wants to hear from me right now.
I'm gonna go out there and remove one of His creations from this universe.
And when I get back I'm gonna drink a bottle of Scotch like it was Chiggy von
Richthofen's blood and celebrate his death."
Col. McQueen, Space: Above and Beyond
(http://www.worldaccessnet.com/~delta6/htbin/delta6.jpg)
-
Check out an article I wrote about this:
http://lephturn.webhop.net/views.htm (http://lephturn.webhop.net/views.htm)
You don't need to map it to a combo view. Actually, the "default" forward view and "forward" view are two different views. I map another button on my stick to the second "forward" view, which is set back and down to see my instrument panel.
------------------
Sean "Lephturn" Conrad - Aces High Chief Trainer
A proud member of the mighty Flying Pigs
http://www.flyingpigs.com
Check out Lephturn's Aerodrome (http://lephturn.webhop.net) for AH articles and training info!
-
Yep, I have the default forward view, the over the nose forward (KP8) view, the look at instrument panel forward view (KP7 + KP1), and then forward with head at top left and up, and forward with head at top right and up (very usefull when taxing and landing).
-
The way I do it, I have forward, rear, left, and right views mapped to two hats, one on my throttle and the other on my joystick. 2 buttons on throttle for up and down.
Mapped down-forward to look at instrument panel. That's "down" button on the throttle and hat forward on joystick or the throttle.
Nexus