Aces High Bulletin Board
General Forums => Aces High General Discussion => Topic started by: Waffle on February 29, 2004, 01:34:10 AM
-
About done with the natural metal look for the p47...figured I'd try it. This is only panels / lines / rivets....no externals have been drawn in or access hatches. No weathering - just the pure metal base. Also / panellines / rivets haven't been "adjusted" yet
(http://www.dangreve.com/ahss41.jpg)
(http://www.dangreve.com/ahss42.jpg)
(http://www.dangreve.com/ahss45.jpg)
-
GREAT "metallic" look.
i have to agree with the other thread though....
rivets are getting a bit out of hand. almost to the point they'd be distracting while flying.
just my opinion
btw look at this pic for rivets:
(http://www.hitechcreations.com/images/dalep51.gif)
thats not too far away and you can not really see them.
again just my opinion
-
The pov on the P-47 is much closer, and I like the way it looks.
Nice job!
-
NICE!!!! didn't know you could do 1024x 1024 in ah1.
This will be very useful when doing aircraft such as the lightning.
-
How do you add such a skin to AH1? I've worked on an F4u1 skin, and would like to give it a test run!
Cya Up!
Dawg
-
You jave to build a small map and save the textures you replace in a "textsrc" folder....after that, you need to build the map then save the built .res file in your ah1 terrains directory. Go offline - load the map and see how the skin is fitting.
-
Really looks promising, good job!
-
Originally posted by JB73
GREAT "metallic" look.
i have to agree with the other thread though....
rivets are getting a bit out of hand. almost to the point they'd be distracting while flying.
just my opinion
btw look at this pic for rivets:
(http://www.hitechcreations.com/images/dalep51.gif)
thats not too far away and you can not really see them.
again just my opinion
If HT flies with this P-51 skin in Aces High 2 (and only he can use this), it would be nice... :D
-
And Only him :aok