Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: FOGOLD on April 14, 2004, 05:13:24 PM

Title: CH Pro Toe brake/y-axis
Post by: FOGOLD on April 14, 2004, 05:13:24 PM

My CH Pro toebrake/Y axis has given up the ghost. I wondered why I couldn't land properly any more!:D

It's no big deal, I never liked the toe brakes. But how do you fix it? Has anyone taken these things to bits before? I dont want to take off the botton and have springs and plastic grommits flying at me in all directions.

Does the bottom come off clean? They are 2 years old and live on the floor (obviously!). It's no shame to them and the rudder function is fine.

Thanks in advance;)

Title: CH Pro Toe brake/y-axis
Post by: Furious on April 14, 2004, 05:39:40 PM

I had same problem.  The wire for the right toe brake had snapped.

It's an easy fix, although lining everything back up to close it is a bit of a pain.

Also voids warranty.

Title: CH Pro Toe brake/y-axis
Post by: LoneStarBuckeye on April 14, 2004, 05:58:14 PM

You might head here:

http://www.ch-hangar.com/forum

Michael from CH Products frequents the boards, and he will probably offer to fix your problem for you (or at least send you a replacement pot).

Title: CH Pro Toe brake/y-axis
Post by: FOGOLD on April 15, 2004, 01:25:03 AM

Thanks all!:aok

Title: CH Pro Toe brake/y-axis
Post by: FOGOLD on April 15, 2004, 07:21:50 AM

Phoned supplier. They will replace them FOC. They carry a 3 Yr warranty. That is fantastic!! Thank you RC Simulations!!:aok  

and CH Products of course.