Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Batz on May 06, 2004, 06:08:09 PM

Title: Question about twin eng RPM control
Post by: Batz on May 06, 2004, 06:08:09 PM

I was tooling around in the p38 offline and noticed that when you reduced throttle both eng responded unless you selected and an individual eng.

I have rpms on a rotary nob and when I reduced rpm only one eng responded.

Is it possible for rpm to act like the throttle, that is both eng respond unilt you select a specific eng.

I only flew the p38 and haven't checked the other multi eng aircraft.

Title: Question about twin eng RPM control
Post by: jodgi on May 08, 2004, 01:15:02 PM

Try to check the axis assignment in setup.