Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: debuman on May 06, 2004, 07:01:25 PM

Title: CH Pro Pedals - toe Brakes?
Post by: debuman on May 06, 2004, 07:01:25 PM: Does anyone know how to get the left and right brakes assigned to the pedals? I've got the CH flight yoke and pro- pedals, but have been unable to get them assigned. I still have to use the C and V keys for the brakes.
Thanks,
Debuman
Title: CH Pro Pedals - toe Brakes?
Post by: DAVENRINO on May 07, 2004, 01:46:44 AM: If ya usin CM go to - http://www.ch-hangar.com
If not (I don' t for AH) go to Select Joystick/L toebrake / CH Peds/ X axis/ Set Input and same for right except Y axis.

DJ229 = AIR MAFIA
Title: CH Pro Pedals - toe Brakes?
Post by: ChasR on May 07, 2004, 07:55:14 AM: If he does that Dave he'll lose rudder control. He needs to set the toe brake inputs to the sliders. Thats assuming he's got the devices combined in control manager.
Title: CH Pro Pedals - toe Brakes?
Post by: debuman on May 07, 2004, 08:40:45 AM: Daverhino,
Thanks for the reply, but I have a question. What is "CM"?

Yes, I have the pedals and the yoke combined into one unit.

Thanks,
Debuman
Title: CH Pro Pedals - toe Brakes?
Post by: ChasR on May 07, 2004, 08:52:20 AM: CH Control Manager = CM

In AH
setup/select joystick/click on left brake under AH control and the first slider under Joystick input/set input. Do the same with right brake but chose second slider/OK.

That should do it.
Title: CH Pro Pedals - toe Brakes?
Post by: debuman on May 07, 2004, 04:36:48 PM: CHASR - thanks. That did it!
Title: CH Pro Pedals - toe Brakes?
Post by: DAVENRINO on May 07, 2004, 04:44:58 PM: Quote
Originally posted by ChasR
If he does that Dave he'll lose rudder control. He needs to set the toe brake inputs to the sliders. Thats assuming he's got the devices combined in control manager.

Debuman, CM is lazy guys way for saying Control Manager.

Chasr, That's why I said if NOT using CM. You are correct if using CM. I just use DirectX inputs for AH. I set mine as stated above with L brake = X , R brake=Y , and Rudder=Z.

DJ229 - AIR MAFIA
Title: CH Pro Pedals - toe Brakes?
Post by: DAVENRINO on May 07, 2004, 04:48:46 PM: OH GOOD ,
I see cya got it working. I am a bit slow responding with the time zone difference.

Dave
Title: CH Pro Pedals - toe Brakes?
Post by: Wmaker on May 11, 2004, 11:11:42 AM: I have Win98SE and old pci CH gear. I think the new control manager only works in XP. I have the newest CH drivers installed and both toe brake axis in the Win joystick setup are seen as gray and I can't enable them. Is there anyway to get pci pedals' toe brakes working under 98SE?
Title: CH Pro Pedals - toe Brakes?
Post by: Soulyss on May 11, 2004, 01:53:25 PM: I'll have to go check when I got home but I just assigned the toe brakes in AH and they seem to be working fine for me.