Aces High Bulletin Board
Help and Support Forums => Aces High Bug Reports => Topic started by: ramzey on June 14, 2004, 12:02:20 AM
-
its actual request to change default view in hangar for convergence settings. Current one dont give chance to set convergence closer then 250. Settings cone is covered by plane and i cannot see numbers and set conv precise. Side view or side back whould be better.
Pressing couple view keys together give nice front quater view, but holding 3 keys for that is a bit annoying. Can i save this view?
regards
ramzey
-
I hate the new AHII hangar. HTC,please go back to the AHI hangar.
-
Hey guys what do you think about the assignment of a weapon to a self choosen key ?
That means in example, in a 109 we can carry 20mm cannon gondolas assigned by default to a precise trigger key (Primary or secondary weapon key I don't remeber well now) but.....i could decide to use my gondolas separately from the other weapons assigning to it another trigger key so I can have 3 weapon keys: Primary, Secondary and eventually another key for gondolas weapons.
This is because I've noticed that in a 109 I usually set the inboard weapons convergence to 650 (but this is not a problem because they are close to the plane centerline), while instead I set the outboard gondolas to 250 so, when i fire to near tgts all is good, while if i fire to far tgts (I could say farther than 400 yards) the gondolas fire is lost because of convergence problems.
Instead I would use gondolas for near tgts and inboard weapons for far tgts.
-
Clouds, this is a bug form. Make sugestions in the Aces High II Forum.
HiTech
-
Ok.
Could you move my previous post in that position please or may I have to copy the post there ?
Thanks
-
This same issue has been posted as a bug in this forum because of the difficulty in setting convergence on a number of planes.