Aces High Bulletin Board
General Forums => Custom Skins => Topic started by: Kev367th on July 03, 2004, 03:00:17 AM
-
Excuse bad screenie ftp is hosing up transfer.
One problem encountered was that the stbd side cannon gets its color from the port side wing (go figure). Only way to get cannon grey was to create a 'repair' panel on port side wing on outer edge of yellow stripe.
(http://www.cyberonic.net/~kreed/182Sqn.jpg)
Available on skins site
http://www.ah-skins.com/
-
It's perhaps my eyes but I find the pict a bit too Magenta (red)
-
Its the tranfer to my remote ftp site, its hosing up the pic.
Post your email I'll send the panel/rives layers.
-
Originally posted by Kev367th
Its the tranfer to my remote ftp site, its hosing up the pic.
Post your email I'll send the panel/rives layers.
Oooh nice Kev! :)
Any chance of those layers too? :)
-
Ok ,I didn't understood your 1st post :)
email is : fdejager(at)club-internet.fr
-
Just use the screen shot from http://www.ah-skins.com :)
(http://www.ah-skins.com/skins/screenshot95.jpg)
-
Fixed the problem was forgetting to change to Binary mode for transfer...DUH!!!!
Next one will be 193 Sqn 1943 "Northern Star"
(http://www.cyberonic.net/~kreed/NortherStar.jpg)
Removed links to PSD files, Lucull is hosting them on the skins site but has removed the weathering to reduce file sizes. There is also a post on the forum explaining some of the layers.
(http://www.cyberonic.net/~kreed/198sqn.jpg)
Once you get your weather layers done you can crank out skins in
4 -5 hours.
Enjoy.
-
Can I have the hstab too please ?
-
sent u an email