Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Udie on October 10, 2000, 01:55:00 PM

Title: Eagle and other Saitek x36 winners or new owners
Post by: Udie on October 10, 2000, 01:55:00 PM

 http://home.att.net/~stickworks/ (http://home.att.net/~stickworks/)   Go to this link to get the files you need to get the stick to work right.  http://home.att.net/~stickworks/swdownld.html#X36DRV04 (http://home.att.net/~stickworks/swdownld.html#X36DRV04)    that's a link to the file that lets you use the x36 usb with analog or CH pro usb pedals.  Get the zip file and read the instructions, it's pretty simple to set up. Make sure you get version 1.4 of the SEG program or the stick will act funny.  

 Once you get used the ergonomics of the stick it's a sweet controller, very acurate.  Hope this helps.....


udie

Title: Eagle and other Saitek x36 winners or new owners
Post by: Robert on October 10, 2000, 02:00:00 PM

THANKS UDIE !!!!
been looking for this post every sence
we got off the phone together.

RWY

Title: Eagle and other Saitek x36 winners or new owners
Post by: 1776 on October 10, 2000, 02:03:00 PM

Also www.saitekhelp.com (http://www.saitekhelp.com)

Title: Eagle and other Saitek x36 winners or new owners
Post by: RangerBob on October 10, 2000, 04:27:00 PM

Please be advised that you do not need this file to use the Saitek x36 combo and the CH Pro USB Pedals here in Aces High. You will probably need them to use other sims. They will work fine without that file.

Just install them normally, and then go the Aces High joystick setup area and assign the rudder axis to the CH Pro rudders instead of the X36 rudder flapper. Also assign the toe brakes to the toe brakes on the CH Products Pedals and they will work fine too.

Ranger Bob

Title: Eagle and other Saitek x36 winners or new owners
Post by: AKSeaWulfe on October 10, 2000, 09:00:00 PM

Rudder recently began spiking when I pressed it and it recentered, it didn't stay "centered". Also, pushing a little offcenter to the left causes spikes and sometimes losing my controls.

Seen any reports like this anywhere Udie?
Thanks!
-SW

Title: Eagle and other Saitek x36 winners or new owners
Post by: eagl on October 10, 2000, 10:40:00 PM

While I was browsing around the file areas Udie listed, I saw a util that reset the windows joystick centers in case they got too porked to calibrate properly...  Can't remember where it was, but I started at the saitek help site.

------------------
eagl <squealing Pigs> BYA
Oink Oink To War!!!

Title: Eagle and other Saitek x36 winners or new owners
Post by: indian on October 10, 2000, 11:50:00 PM

I pointed out at the con that if you have a PDPI card and maybe any other game controller you dont need this utility to use pedals in ACES HIGH they calibrate fine in windows with 2axis 2 button joystick selected and not attached, just the pedals hooked up.

------------------
Tommy (INDIAN) Toon
Indians Home page were links to help pages can be found.
Indian's Homepage (http://www.geocities.com/~tltoon)