Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Bluefish on July 28, 2004, 11:02:31 PM

Title: WEP Inoperative
Post by: Bluefish on July 28, 2004, 11:02:31 PM

Last week my WEP suddenly stopped working on all WEP-enabled planes.  I've got it programmed to the default "P" key; I made sure the RPM and throttle are both run up to the max.  Any suggestions greatly appreciated

Title: WEP Inoperative
Post by: fuzeman on July 28, 2004, 11:08:00 PM

Double check the key-mapping to make sure that hasn't changed somehow. Also, if you have a throttle controller, when you calibrate it hold short of max travel a very little bit. That will ensure when you do push stick to the max it will be full throttle.
Two suggestions for a penny a piece, or my two cents worth of advice.

Title: WEP Inoperative
Post by: flyingaround on July 29, 2004, 12:28:27 AM

Actually, think it's a bug.  I have had this happen to me MANY times, but never thought much of it, UNTIL me and 4-5 squadmates were doing a fighter sweep, and within say 1-2min, four of us had this problem.  THEN again on our next fighter sweet.  1st was in FW190D, 2nd in Spit 9's.  So wasn't just me, and if multiple guys having same problem at same time, I would say Bug.

Needs looking into.

Title: WEP Inoperative
Post by: Bluefish on July 29, 2004, 06:10:48 PM

Thanks for the responses; I recalibrated my throttle (taking the hint not to push it all the way forward) and that seems to have done the trick.