Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: ramzey on August 12, 2004, 07:58:07 PM

Title: stick problem need solution
Post by: ramzey on August 12, 2004, 07:58:07 PM

hallo

after infamus dead of my saitek evo i brought logitech extreme 3d pro. But all the times im getting weird problem. Even after plug and unplug before AH lunch  and after calibration in AH my stick is rolling right all the time. Weird is its not constant turn but 1 step every couple secounds (about 15-20 deg roll right). I allready chk damper and deadzone, and try many settings but nothing help :(

any advices how to fix it?

regards
ramzey

Title: MAybe a suggestion!
Post by: bandit752 on August 15, 2004, 08:15:38 AM

I too have the x45 and had problems with the rudder but resolved that with updated drivers!! Shame you didnt keep that stick!
DID you checked the drivers and see if you have the correct ones!
I also had that problem, but downloading the new drivers and assigning buttons to the trims it works fine now! I also assigned a button for auto trim!! If I see the trim is out I just hit the auto trim to bring it back to balanced state!!

Did you calbriate the stick in both windows and AH! The calbriated center position could be out???

I would first compare the drivers see which one you are using through the device manager and write that down then see wha tthe lateset ones are at the logi support page??

McCuskey VF15

Title: same problem
Post by: Jnuk on August 19, 2004, 06:50:01 PM

my logitech extreme 3d pro has the same problem.
i have to calibrate it every time i fly, and the calibration only lasts for 1 or 2 flights.
it kinda jerks over to the right every once in a while, and it does it just about every time i pull up.  makes lining up a bit of a chore

Title: stick problem need solution
Post by: Eagler on August 19, 2004, 07:05:18 PM

USB?

have you tried a powered hub if so?

Had to get one for my X45 setup

just a suggestion

gl