Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: TEShaw on September 20, 2004, 08:03:13 PM

Title: Arrgh! Is there a keystroke for hangar?
Post by: TEShaw on September 20, 2004, 08:03:13 PM

Is there a key command to move from tower to hangar (and back) without having to open and close the clipboard? (And wait for it to open and then wait for it to close.)

Pretty tedious when you're waiting for something to become available.

(And no, I don't want to walk.)

regards, Airman T. E. Shaw

Title: Arrgh! Is there a keystroke for hangar?
Post by: Soulyss on September 21, 2004, 10:37:33 AM

I don't know about a keystroke but if you go to setup and GUI you can change the clipboard time and time in transit between the tower and hangar to be near instantaneous.


and since I can't resist it anymore... you can always suck it up and fly a different plane.  :)

Title: Arrgh! Is there a keystroke for hangar?
Post by: fuzeman on September 30, 2004, 12:37:59 AM

You could probably use the .plane X, .ord Y1 Y2 Y3 and .fly Z commands but you'd have to know exactly which plane is which, what and how to use the .ord command and same with which runway corresponds to .fly 1 etc.