Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Griego on September 28, 2004, 09:14:40 PM

Title: elevator trim
Post by: Griego on September 28, 2004, 09:14:40 PM

Can't get elevator trim to stay or even move although i have it mapped out in both keyboard and stick.

 The elevator stays stuck in low. After i use the angle trim or speed trim it goes back to the same old setting low.

 I have to constantly hold the stick to keep it from going down.

what could it be?

 I appreciate the help thank you.

 I'm thinking of giving AHII a two week trial run.

 

 Never mind.  I hadn't calibrated the rotoray nobs.

Title: elevator trim
Post by: JB73 on September 28, 2004, 11:14:58 PM

if you have rotaries mapped for trim you must calibrate them with your stick.