Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: Waggle2 on October 12, 2004, 10:39:15 PM

Title: lead computing gunsite?
Post by: Waggle2 on October 12, 2004, 10:39:15 PM

In another post someone mentioned:

"I'd suggest going to the offline mode, and turning on the "lead computing gunsite." "

How does one turn that on? I've looked in the AHII help file and can't find it.

Thanks.

Title: lead computing gunsite?
Post by: fuzeman on October 12, 2004, 11:05:06 PM

You go into setup and arena settings and under Flight Mode Flags you enagle the Lead Computed Gunsight, I think I left out one step in the location processs though.
Hit 'Ctrl-tab' to enable Friendly lock and at that point 'tab' or 'Shft-tab' will highlight the target. 'Tab' to cycle through all targets in your view and 'Shft-tab' to highlight the centermost one. It brings up small green +'s that show the exact lead needed to hit the target. You have one + for primary and one for your secondary weapon.

Title: lead computing gunsite?
Post by: Waggle2 on October 12, 2004, 11:11:36 PM

Thanks.

Title: lead computing gunsite?
Post by: TequilaChaser on October 12, 2004, 11:35:25 PM

this only works in the Training Arena I believe, someone correct me if I am wrong please!

Title: lead computing gunsite?
Post by: fuzeman on October 13, 2004, 12:24:54 AM

The LCG is enabled in the TA and you only need to enable friendly lock and highlight your target there. If offline, you need to turn the LCG on in Flight Mode Flags.