Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: dmdchief on October 16, 2004, 10:13:09 PM

Title: cant trim nose down
Post by: dmdchief on October 16, 2004, 10:13:09 PM

for some reason I can only trim down half way. does not make any difference what plane the trim will only go to the middle of the gage never down enough to bring the nose down

anyone else have this problem. tried unmapping and re mapping but that didnt help

Title: cant trim nose down
Post by: BenDover on October 17, 2004, 05:46:32 AM

Are you using a rotary wheel?

If so you'll have to calibrate it.

Title: cant trim nose down
Post by: dmdchief on October 17, 2004, 01:25:50 PM

no all ch gear but even with the keyboard I cant bring the needle down past the half way mark