Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: bojc on April 22, 2000, 11:03:00 AM

Title: auto pilot problems
Post by: bojc on April 22, 2000, 11:03:00 AM

Need some help with this one. Can't seem to keep the plane on auto more than 15 seconds or so. hand off controls, hit auto, lights on
plane levels, then pop of it goes. What am I missing.  

Title: auto pilot problems
Post by: indian on April 22, 2000, 11:43:00 AM

set you dead space higher in the setup menu you have a lot of wiggle in the joystick basicly and its turning off the auto.

------------------
Tommy (INDIAN) Toon
  1st Aces High Trainer Corps.
Home of The Allied Fighter Wing A.F.W.
A.F.W. Homepage (http://www.geocities.com/~tltoon)

Title: auto pilot problems
Post by: Minotaur on April 22, 2000, 08:47:00 PM

Spiking can cause this as well.

Go to Set-up --> Joystick

Watch the scope for a while make sure that it does not spike.  Joystick re-calibration may be neccessary and as Indian said you might need to adjust you deadband sliders upwards a bit.

Good Luck!   (http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)

------------------
Mino
The Wrecking Crew

Title: auto pilot problems
Post by: skippy on April 22, 2000, 09:41:00 PM

Hmm  often I can't get it to release and end up riding it into the ground in the heat of "combat".

Title: auto pilot problems
Post by: Wyrm on April 23, 2000, 11:12:00 AM

im using Force feedback pro and havin same problem i just try and center it and hope it stays (http://bbs.hitechcreations.com/smf/Smileys/default/smile.gif)

Title: auto pilot problems
Post by: air_spro on April 23, 2000, 05:10:00 PM

Try Robert's settings , they are working ok on my MS FFBack stick . But you still have to center the joystick before it will stay in auto trim .
 http://members.xoom.com/awcon99/jssetup1.htm (http://members.xoom.com/awcon99/jssetup1.htm)