Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: nturbiz on November 26, 2004, 07:59:32 PM

Title: Target altitude won't calibrate Help!!!
Post by: nturbiz on November 26, 2004, 07:59:32 PM

When I want to bomb and I go to calibrate the bombsight I can't click on a target to get the target altitude. I bring up the clipboard and then I can't get it to do anything. Please Help. Thanks

Title: Target altitude won't calibrate Help!!!
Post by: Roscoroo on November 26, 2004, 08:22:49 PM

you dont have to anymore ... its been changed

All ya have to do is hit enter cal mode and then hold the Y "Cal" key down for 2-4 secs .

Title: Target altitude won't calibrate Help!!!
Post by: Flossy on November 27, 2004, 07:02:28 AM

As Roscoroo says, only press the Y key for a few seconds now - the longer the better, but at least 2 seconds.  The display will then show your Calibrated Speed.  Then if you click on the E6B and check your speed there they should match.  If not recalibrate until both speeds match; the closer they are, the more accurately you will hit your targets.  :)

Title: Target altitude won't calibrate Help!!!
Post by: nturbiz on November 27, 2004, 11:52:19 PM

OK, Thanks guys I got it working fine. A direct hit on the first try now. Thanks