Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Max on December 21, 2004, 09:10:22 AM

Title: CH Throttle USB problem
Post by: Max on December 21, 2004, 09:10:22 AM

In middle of flight/fight all throttle axis & button input will cease to exist. The throttle will still show in the center J-stick window of set-up, just no input info. Same as far as WinXP gaming device CP's...shows as being there but no input.

If I disconnect/reconnect USB, recal in WinXP and then AH@, I'm good to go again. Can anyone suggest what's causing this to happen?

DmdMax

Title: CH Throttle USB problem
Post by: Sandog on December 21, 2004, 10:27:11 AM

Dmax

  I have a USB printer that will affect my CH pro gear I have to fly with my printer off or I sometimes lose the device.
 If your plugged into a hub try plugging directly into a usb on your
computer. one last thing you can try, go to  device manager look under usb controllers, usb roothub, power management and make sure allow the computer to turn off device to save  power  is unchecked.

Title: CH Throttle USB problem
Post by: Max on December 21, 2004, 11:11:10 AM

thanks sanddog, i'll give that a check