Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: WOZ30BAT on December 24, 2004, 08:15:31 AM

Title: Got me a X52 stick..need help
Post by: WOZ30BAT on December 24, 2004, 08:15:31 AM

I want to map the rotary knobs to my rudder trim & pitch trim, but can't figure it out. I mapped slider to rpm control..good idea?  Appreciate any advice.

Title: Got me a X52 stick..need help
Post by: Gunthr on December 24, 2004, 08:39:09 AM

It appears that AH doesn't see these two rotary wheels.

I had the slider set for pitch trim because its more critical in combat for me than rpm, but its personal preference.

Title: Got me a X52 stick..need help
Post by: Eagler on December 24, 2004, 03:11:33 PM

yes you can do that with X52

go into joystick setup and spin your rotors around. You'll see the value change. then just assign that rotor to whichever trim you want it to control.

I have the slider as aileron trim, the big one on top as rudder trim and the small one lower left as vator trim

Title: Got me a X52 stick..need help
Post by: Gunthr on December 25, 2004, 06:04:18 AM

Thanks, Eagler.

Title: Got me a X52 stick..need help
Post by: WOZ30BAT on December 25, 2004, 07:45:49 AM

Thanx & Merry Christmas