Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Zellak on December 27, 2004, 08:00:22 PM

Title: New, need help with x45 throttle+CH Fstick
Post by: Zellak on December 27, 2004, 08:00:22 PM

Hello, I'm from WW2OL and wanting to give this a try. I use an x45 throttle combined with the CH Fighterstick. How do I set these up in game? I finally got my x45 rudder and throttle going (rotary also) along with the stick of the ch. However when I map buttons they don't seem to work... not even the engine. Is there something I'm over looking?

Title: New, need help with x45 throttle+CH Fstick
Post by: thebest1 on December 27, 2004, 08:03:06 PM

in set up, joystick, settings, select joystick.  set the inputs for the throttl to "throttle" and so on.

Title: New, need help with x45 throttle+CH Fstick
Post by: Zellak on December 27, 2004, 08:06:15 PM

ok and what of the buttons under that? do I have to select the bottons in stick map and then match them up in stick select? Also How do I get the x45 throttle to activate in stick map over the ch fighterstick?

Title: New, need help with x45 throttle+CH Fstick
Post by: Zellak on December 27, 2004, 09:26:15 PM

heh now im really getting frustrated.. I can only use buttons on the throttle or the stick... NOT both of them.. so if I set to throttle only throttle works and if I set to stick only stick works....

Title: New, need help with x45 throttle+CH Fstick
Post by: JB73 on December 28, 2004, 08:44:18 AM

hmmm i use the exact same setup with no problems.


are yuo using the programming software for both the CH and the x45?

i am, and all is well. all buttons programmed as key strokes.


try setting those up, then deletingthe stick.cfg file in the AH game folder.

enter the game fresh it will make a new file, and you should be able to assign the axis fine then.