Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Max on January 06, 2005, 10:54:07 AM

Title: Converting slider throttle to TRIM
Post by: Max on January 06, 2005, 10:54:07 AM

The throttle slider on my Saitek Evo is rendered useless by way of my CH Throttle. So I says to myself, "Max, why don't you use it for elevator trim." In looking at the joystick setup I see an AH function called Roll yaw under AH controls..which I set to the Evo and then to the Z axis. When I went to stick mapping to finish the assignment, all I saw were the hat and button boxes. What am I doing wrong here?

DmdMax

Title: Converting slider throttle to TRIM
Post by: DAVENRINO on January 06, 2005, 01:00:09 PM

Hmm....
Not sure why you chose Yaw roll.  I selected RPM1 under AH controls.