Aces High Bulletin Board

General Forums => Terrain Editor => Topic started by: TequilaChaser on February 04, 2005, 11:16:55 AM

Title: placing tiles
Post by: TequilaChaser on February 04, 2005, 11:16:55 AM

is there any way to place tiles in a just a particlular section of a grid section? like say in a 1/4 or 3rd or 2 3rds?

say have part of a grid ( a grid has 9 vertices) to where it contains both land and water, or do you got to make your own custom tiles to do this?

you can set your alt different for each vertice so you should be able to seperate a specific grid to have both water and land?

if this is possible with the basic tiles I am unable to figure it out


help please




btw who made the new indilses map and what prggy did you use?

Title: placing tiles
Post by: hitech on February 04, 2005, 11:25:19 AM

No on tile type , Yes on tile sub type.



HiTech

Title: placing tiles
Post by: NHawk on February 04, 2005, 11:27:52 AM

What you want to do can't be done except with custom tiles and alphas or maybe a 3D object. I'm not sure with the object part of this yet.

And even then, the water shown on your tile will still be able to be driven over by a GV because it will be recognized by AH as terra-firma.