Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: 68DevilM on February 05, 2005, 09:20:59 AM

Title: Hard Drive Slave
Post by: 68DevilM on February 05, 2005, 09:20:59 AM

can anyone tell me if i did this right

pics are a little fuzzy and large but  the hard drive closest to to the front is my primary and the pins are the center set, and the rear one is my storage or slave and that one is  
the second set from the bottom.

Title: Hard Drive Slave
Post by: Roscoroo on February 05, 2005, 01:00:38 PM

set the primary as master

the secondary as slave

enter the bios and do the (auto ) for each drive   it should reconize bolth drives ..

Title: Hard Drive Slave
Post by: 68DevilM on February 05, 2005, 02:00:36 PM

Quote

Originally posted by Roscoroo
set the primary as master

the secondary as slave

enter the bios and do the (auto ) for each drive   it should reconize bolth drives ..

i knew it..

i thought i had the primary as the master and the second as slave.

dont know how to do bios?

Title: Hard Drive Slave
Post by: AmRaaM on February 05, 2005, 02:41:32 PM

if its ATA capable..go ATA ..(the red connector)