Aces High Bulletin Board

General Forums => Terrain Editor => Topic started by: Raptor on February 10, 2005, 10:14:46 PM

Title: terrain over lay
Post by: Raptor on February 10, 2005, 10:14:46 PM

how do you change the terrain overlay (such as trees, shrubs, etc.)

Title: terrain over lay
Post by: NHawk on February 11, 2005, 05:25:38 AM

If you're talking about the trees you see from the air, they are in tiles stc1, stc2, stc3 and stc4 and their corresponding alpha files.

If you're talking about what you see from the ground, I do believe you need to use the object editor. If not, then they are in bush2, bush4, grass2, t-line3 and their corresponding alpha files.

Title: terrain over lay
Post by: kanttori on February 11, 2005, 04:20:55 PM

But how you can edit the terrain overlay? I have asked this same question in an other thread... :confused:

Title: terrain over lay
Post by: hitech on February 11, 2005, 04:38:57 PM

You can't edit them, you would need to make new ones.

HiTech

Title: terrain over lay
Post by: kanttori on February 11, 2005, 05:49:00 PM

Ok! That is just I am going to do, but it should have been nice to look them closer!

So I built them with the Object editor after Squirrel has created the textures. But what I am texturizing? Must I create 4 x half mile x half mile subtiles and then handle them together (1 mile x 1 mile) in the object editor?

Can you please give us short instructions to built those base tiles! :)