Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: Tilt on August 18, 2005, 10:59:52 AM

Title: Stiffening up the X52
Post by: Tilt on August 18, 2005, 10:59:52 AM

I just put a rubber washer in the cavity where the upper side of the spring locates. A large tap washer will do.

This pre compresses the spring and makes it a bit stiffer.

Spring feed back at the end of travel is a bit more noticable now.

Title: Stiffening up the X52
Post by: humble on August 18, 2005, 05:12:03 PM

Hmmm....

Do you have to take it apart or did you cut the washer and pop it on that way????

Title: Stiffening up the X52
Post by: Tilt on August 18, 2005, 05:34:37 PM

I cut the washer......the spring holds it in place............ its easily  reversable