Aces High Bulletin Board
Help and Support Forums => Technical Support => Topic started by: Golfer on September 10, 2005, 12:19:25 AM
-
I'm stumped on this one. I traded in my old Saitek X-45 for a new X-45 after I wore out the hat switch. When I connected the new stick and calibrated, I found that the sensitivity was much more...sensitive than previous.
Checking the joystick settings in-game I find that with what corresponds to 1/2 deflection of the stick the input goes from 1/2 back or forward elevator (1/4 from the bottom of the blue box) to full with nothing in between.
Moving the stick smoothly forward to the stop or pulling it back to the stop should result in a linear input line. Mine is linear until the last 1/4-1/3 to the edge of the box and it drops immediately to full deflection. I can't even 'desensitize' the stick using the sliders.
I thought it might be the new stick, so I re-traded it in and a new stick (completely different lot number for production) does the same thing.
Any help would be appreciated.
Two visual aids to hopefully help:
(http://www.onpoi.net/ah/pics/users/621_1126329314_ahss24.jpg)
(http://www.onpoi.net/ah/pics/users/621_1126329483_ahss25.jpg)
-
did you calibrate in windows first?
-
whenever I have changed out my X45 I have had to de-install/re-install the Saitek software, calibrate in windows, calibrate in AH and reset the stick in AH for it to work properly
what happens if you bring your 0 - 90 sliders all the way to the top and the dead pan, dampining all the way to the bottom? It would be very sensitive but should be smooth with very small inputs