Aces High Bulletin Board
General Forums => Custom Skins => Topic started by: FTJR on September 19, 2005, 09:11:50 PM
-
Hey Kev, have you submitted that 3 sqn RAAF B pony skin yet? I cant wait to see it.
:O
-
Not finished yet, tweaking undersides and chips.
Pic later
-
As promised -
One little bit left: fade underside dirt between two different texture places.
Oh and the other lower undercarriage door. (just noticed).
(http://www.cyberonic.com/~kreed/ponyb4.jpg)
(http://www.cyberonic.com/~kreed/ponyb3.jpg)
(http://www.cyberonic.com/~kreed/ponyb5.jpg)
-
Finished it!
(http://www.cyberonic.com/~kreed/finponyb.jpg)
-
Kev on the post before this "done" post, the belly screenshot shows a black section on the middle under the port wing/port wheel door. What's that?
-
There are slight differences in layout between the Pony D and B.
Was a part that I missed, but is now fixed.
-
ah, cc
lol for a minute I thought it was intentional! :P
-
Nice job Kev, look forward to seeing/using it in game :aok
-
Thanks,
will submit it this weekend hopefully will squeeze in next weeks possible skin updates.
As I said earlier - fixed bottom
(http://www.cyberonic.com/~kreed/finponyba.jpg)
(http://www.cyberonic.com/~kreed/finponybb.jpg)
-
Nice skin,
I see you are experiencing the P-51 light reflection bug. Note the dark area to the rear of the radiator air intake on the bottom of the plane. It's also visible under the nose, producing a discontinuity in color where the nose joins the gear area. (I think this is a characteristic of the 3D model, which should be fixed).
BTW, it wouldn't hurt if you added a support comment at my bug report thread "P-51 light reflection bug" in the "AH2 Bug Reports" forum. http://www.hitechcreations.com/foru...hreadid=160215[
-
is it just me or dose the p51b look out of proportion?
-
It's just you. If anything the P51B nose is a hair longer than the P51D nose (check the skin viewer, just arrow up and arrow down between the D and B).
-
prob is me..just looks kind of dumpy
-
I think that the dumpy look is mostly a function of the AH "fisheye lens" view from certain angles. Perhaps the nose section is a bit too blunt; I don't know... Overall, however, the new model is better looking than the old, which was too skinny-looking from the side.
-
I think the proportions are correct, that is to say that the proper dimensions were modeled in. I think the "dumpy look" comes from tbe squared-off surfaces on the model, such as the top of the tail, the bottom of the oil cooler, the bumpy curves of the nose. I think the nose is a bit plumper, but when they reduced the polys on the 3d model it lost some of its real look