Aces High Bulletin Board
Help and Support Forums => Help and Training => Topic started by: viper215 on December 25, 2005, 11:08:47 PM
-
I just hooked up my ch throttle,joystick,rudders. took me 15 mins just to get them to work the right way. NOW all my joystick buttons reset and i cant get them to go back i try to set them but nothing any help?
-
what kinda joystick?
-
Everything is CH products
-
CH?
-
My squadie just logged in last night saying that he lost his in game mapping because (for some reason) he had to plug into a different set of usb ports. You didnt really say what preceeded your problem. But my squadies problem could have been avoided.
If you use control manager to assign all three (throttle, pedals, and stick) as one device, windows and therefore Ah will always see it as that same one device no matter how and where you have all three plugged in, and you wont lose mapping from your pc detecting a different setup than previously used. You might want to consider doing this if you havent already.
-
I had a problem with the CH USB gear when I tried to hook it all up to an external USB hub. I bought an internal PCI slot USB hub and used that and it worked fine. I'm not sure if that's your problem though. I'm not sure what you mean when you say you got it all set-up and it works but your buttons are all reset..Are you using AH to try to assign functions or Control Manager?
Zazen
-
why I love my old Analog CH Fighter Stick and stuff, got memory chip built into the base, never loses anything......stick is just worn out though...........
in AH you got to set all inputs on both sides of the screen click apply/ok
same when stick mapping & keymapping........
not up on CH Manager, for that is with CH Products USB stuff, but sounds like if ya use it it holds same purpose as the memory in the old analog sticks........
checkout stickset up on netaces.org or Aces High Help on the website...........
to add, I agree with Murdr, if ya not using any stick-based software to set it up, when you unplug it you lose everything.....the way of USB
-
Just to clearify, I use the AH stick mapper to assign all the functions. I just use the CH manager to make my rig an 8-axis 32-button device for the reasons already stated.
-
Ok when i set it up my new throttle turned the plane the rudders were the throttle and god knows what the joystick was doing. I fixxed all that the throttle controls the man and rudder petals is the rudder now. But the standard buttons that were used to fire the guns dont work. I tryed to reset them back in the joystick map but it wont set anything if that helps. Im just going to send the throttle back or sell it if i cant figure it out.
-
Tinman of the Damned just posted this to our maillist today it may help ya viper
All of you guys with new CH gear need to go here:
http://www.ch-hangar.com/ to check out the prepared profiles for Aces
High. They are a good place to start then go here
:http://ftp://ftp.chproducts.com/pub/CHCMv40.exe and get the tutorial
Good Luck
-
I manually set my stick up in AH settings. All ch. Never had any problems with them losing map.