Aces High Bulletin Board

General Forums => Aces High General Discussion => Topic started by: Brenjen on April 06, 2006, 10:40:34 AM

Title: question
Post by: Brenjen on April 06, 2006, 10:40:34 AM

Do the CV's count as airfields toward ( or against ) the reset? As-in...if one country is down to two land based airfields they get reset even if they have a cv up ( an airfeild ) or do they lose the reset when it is sunk or when the port it spawns from is taken? Basically does the three airfield rule mean three LAND based airfields I guess is my question. Can anyone clarify this point of interest for me? Thank you

Title: question
Post by: killnu on April 06, 2006, 10:52:18 AM

last i checked, cvs count toward a reset.

Title: question
Post by: WMLute on April 06, 2006, 11:04:13 AM

yup. they count.

Title: question
Post by: Brenjen on April 06, 2006, 11:18:47 AM

O.K. so; if one country has two land based airfields & a CV they still have the required three airfields. Does the reset occur at the point when the C.V. is sunk? Or when the port it spawns from is captured?

Title: question
Post by: Donzo on April 06, 2006, 11:28:39 AM

I would say when the CV is sunk and has respawned.  If you notice there is a system messge when a CV respawns after it's port has been captured:
"System: Field 204 has been captured by the Bishops" (204 being the CV)

Title: question
Post by: BlkKnit on April 06, 2006, 11:31:50 AM

It would have to be when the originating Port has been captured and after the CV has been sunk and respawns (to a different country...the one that now controls the port). Then the CV has been lost / captured and reset should occur.

Title: question
Post by: hubsonfire on April 06, 2006, 11:32:15 AM

I think Donzo is correct.

Title: question
Post by: Brenjen on April 06, 2006, 11:45:07 AM

Thanks! And no Donzo I never noticed that message inparticular..I see the messages saying one country or the other has caputered XXX but I never knew it posted that message when the CV respawned after a port capture. So thanks again, now I know I was correct in trying to protect the port & thus the CV to help stave off the reset.