Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Yaks on May 06, 2006, 06:21:55 PM

Title: CH Rudder Pedals Prob
Post by: Yaks on May 06, 2006, 06:21:55 PM

Got new puter -stick was easy to set up but the pedals just r a bear. I set them up in Windows but I have my throttle set to z- axis on my stick. This seems to be the same axis that the pedals want to use. Any hints?
Windows XP Pro -CH Flightstick USB -CH Pedals USB -Intel 950 -Nivida 7900GTX -Soundblaster XFi

Title: CH Rudder Pedals Prob
Post by: StarOfAfrica2 on May 07, 2006, 01:42:21 AM

There should be 2 of them for the Z axis.  One says "Z axis", the other should say "Z rotation axis".  CH pedals work on the Z rotation axis setting.  At least thats how mine is.

Title: CH Rudder Pedals Prob
Post by: Yaks on May 07, 2006, 01:05:40 PM

Star TY for your reply, that may be the issue, there is no "Z rotation axis on my listing, and I don't know how to go access it.

Title: Ch Pedals Prob
Post by: Yaks on May 07, 2006, 01:07:24 PM

Thanks Star - There is no listing for the "Z rotational axis", I need to find out if its a fault in my new system.
Yaks

Title: CH Rudder Pedals Prob
Post by: The Fugitive on May 07, 2006, 01:21:01 PM

Are you using the CH software?

For mine, in windows the stick and throttle show up with the CH interface, and my pedals as a "USB adaptor" seeing as mine are old analog connected with an adaptor. Clicking on each controller shows each controller axis, each having a Z axis.

Same as for in the game, you select each controller, and set the individual axis there too, each has a z axis there too.

So set each controller individually in both windows and the game and you should be ok.

Title: CH Rudder Pedals Prob
Post by: StarOfAfrica2 on May 07, 2006, 06:24:39 PM

Doh!  Sorry I didnt see yours was USB.  Using USB your pedals are a seperate entity from your joystick, unless you are using the CH CM software to combine them all into one device for AH.  If you arent, then you have to go into the joystick select menu and set the rudders to the rudder pedals, not to the joystick.  Then there will be a seperate Z axis for you to map the pedals to.