Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: GRUNHERZ on May 19, 2006, 09:30:05 AM

Title: How do you set up thye CH Hotas Throttle "mouse" thingy
Post by: GRUNHERZ on May 19, 2006, 09:30:05 AM

Hello,

I just gota full CH hotas/pedals nad I'm seeting it all up. So far its fun and a whole new learning curve.

I had one question, how do you set up the little mini joystic on the CH throttel to act as a mouse in AH.

Also i'm curious if anybody has any other ideas how to use it?

Thanks

Title: How do you set up thye CH Hotas Throttle "mouse" thingy
Post by: Callisto on May 19, 2006, 09:58:37 AM

The only way i was able to set up mini stick as mouse is by using CH software.

You gonna have to set ministick axis as mouse in CH software.

Title: How do you set up thye CH Hotas Throttle "mouse" thingy
Post by: 38ruk on May 19, 2006, 12:53:26 PM

I was using mine for elevator and roll trim , its good for emergency pull outs in a compressed dive , but thats about it cause it doesnt hold the setting . You have to hold the ministick in position to keep it trimmed

Title: How do you set up thye CH Hotas Throttle "mouse" thingy
Post by: Auger on May 23, 2006, 02:37:17 PM

I initially used it as a mouse through the CH software.  It wasn't as easy to control as the real mouse and getting it to click without it moving away is an art form.

So I changed it and set it up to send keystrokes.  Up/down changes the engine RPMs and left/right zooms the map in and out.