Aces High Bulletin Board
Help and Support Forums => Aces High Bug Reports => Topic started by: Simaril on June 03, 2006, 10:10:06 PM
-
Since 2.08 patch 0 -- when I'm in tower of CV, all looks fine..but when I click hangar, I get invisible CV. I can see the wake behind, and the water beneath, from perspective of the underside of carrier deck. No planes or loaduts are visible.
I can go to a land field, set up the loadout, return to the carrier hangar and click on the plane list, return to the tower and click H to launch.
However, when carrier was down the hangar was greyed out -- is this a new feature?
-
I can verify the invisible CV hangar. The clipboard is there, so plane selection is OK. But no loadouts are visible.
-
yep have that too.
squadie found that if you hit gunsight zoom you can see a section of hanger and then you can use view keys to kinda work around
-
Same here - no CV hanger
-
Only workaround I have found is to go to a field to carry out your loadout, then go back to the tower, and transfer to a CV. The loadout will follow you to the deck.
-
I get the same thing, I too, go to a field, load up and then go back to the CV.
-
cv hanger is working for me now
-
Once in the CV hanger, adjust 'detail' slider to the left until you see the hanger.. fixed 8)
-
Sure enough, I have to have the ground detail set to half to even see the CV. Maybe time to start testing at the min sys requirements, or raise them?
-
i see hangar, but now have a problem that when in the hangar, and going to external view mode the CV in invisible, im running almost max graphics settings too