Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: mia389 on June 15, 2006, 03:18:24 PM

Title: Stick maping
Post by: mia389 on June 15, 2006, 03:18:24 PM

When Im a gunner in bombers my trigger button only fires one gun. I fixed this by maping my trigger fire to fire all instead of firing primary. When I jump in a fighter now my tigger button will fire both guns which I dont want. I maped my bomber maping in controler figure 3 but how do I use this confuration without having to go to it everytime to change it when flying bombers? Is there a dot comand or something? If I cant I suggest that all guns in bombers be fired with primary trigger instead of All.  I used to be able to shoot one gun in bombers by using my cannons button or secondary weapon i think. All guns was primary but now that has changed to all guns. Kind of confusing

Title: Stick maping
Post by: ridley1 on June 17, 2006, 06:23:53 AM

Off the top of my head...I think that you';; have to set up your stick for a different mode when your gunning.

I have a saitek 52, and I have it mapped slightly different in the SST software for when I'm in a bomber.

Title: Stick maping
Post by: Schatzi on June 17, 2006, 06:33:47 AM

If you set up your stick set Mode3 for bomber (ie fire button to Fire all) you need to assign a button or key to switch between the modes.

I havent done that myself, so i cant tell you what the command is, but id guess it would be something like "Select stick Mode" or "Mode selection".... just go hunting for it in the setup.

Title: Stick maping
Post by: x0847Marine on June 17, 2006, 08:19:40 AM

Try mapping, uh "select secondary", or something to your backspace...  

I have never used, or installed the SST software...

Title: Stick maping
Post by: mia389 on June 17, 2006, 05:11:43 PM

Thanks guys, I maped control Modes 1,2,3 now. Didnt relize you could map them :-).