Aces High Bulletin Board
General Forums => Hardware and Software => Topic started by: Vudak on August 07, 2006, 09:23:56 PM
-
Hey all,
With my X45 dying a slow, painful, lingering death, and the discontinuation of the model, I have finally bit the bullet and ordered myself a full CH setup.
I am sure I will be frustrated beyond tears in the coming weeks once they get here (should be later this week).
Basically, this means I have to relearn each plane's edge - a very simple task :rolleyes:
I just don't want to do this anymore then once more. That's why I'm asking ahead of time if anyone has any stick scaling advice for this setup. I usually fly a Corsair and I fly it slooooow with lots and lots of flaps, if that makes any difference.
Is there any chance someone could post a screenshot of their scalings, or, if this is possible, email them to me? Vudak at Yahoo . com
Looking forward to extreme frustration in the coming weeks, some serious TA time, and all that good stuff :D :aok
Thanks,
-
Hi
Just some time ago I buy a CH FighterStick and I use it paralel with my old Saitek X35T throttle.
The CH's silk smooth and precis action hepls a lot when you are flying on the edge of the stall.
I didn't touch the scaling setting at all.
-
Vudak
CH gear hear and F4u afficiianado.
Scaling =0
You'll be amazed.
Oh and get TIR http://www.naturalpoint.com while your switching.
Hell your messing up everything anyway, might as well get rid of the hat views.
I did both at the same time... I sucked for awhile but you come back stronger.
Balsy
-
Thanks everyone,
Silat was kind enough to email me his scaling settings, so I'll give them a go. Many thanks to him!
As far as TIR... Sir, I get *enough* flack from friends and family over this game :D
... Anyway, I think when the new gear comes in later this week, I may just take a baseball bat to my old gear - Cortez style... Unless anyone wants them for parts? (Salvage only, my friends :) )