Aces High Bulletin Board

Help and Support Forums => Help and Training => Topic started by: Geeb 2 on August 23, 2006, 08:31:31 PM

Title: G damn new js config
Post by: Geeb 2 on August 23, 2006, 08:31:31 PM

ok i just blew a 15k buff run b cause i hit primary fire instead of secondary, i have the primary selected for all guns. now if i am in a buff posf6 & i press the primary aka trigger wtf should happen? this wasnt an issue b4 the goofy config setup. make it like 2.err 0 3? the old AH vox worked, & js config was realatively long but... it did WORK.

Title: G damn new js config
Post by: TequilaChaser on August 23, 2006, 08:52:27 PM

check out Hammers joystick/controller setup write-up ( do a search on these boards/this forum ) or check netaces.org, it is so simple if you take a few minutes to read up on it.

Also, please edit your TITLE on this thread, it would be much appreciated


if you can not figure it out email the trainers at:
trainers( @ ) hitechcreationsdotcom to meet you and get you fixed up

Title: G damn new js config
Post by: Schatzi on August 24, 2006, 03:26:29 AM

http://www.netaces.org/joystick.pdf



The new setup does work as well. IMHO its even easier to grasp then the old one. But youre right, its not the same and it need some TIME and EFFORT to change the setup.


My recommendation would be to set up "Mode 3" as Bomber Setup and assign a key to switch between the modes.
Then you can assign a "Fire all" for gun positions and a "Fire Secondary" as bombs away.