Aces High Bulletin Board

General Forums => Hardware and Software => Topic started by: dusty on December 30, 2006, 01:58:30 AM

Title: ch products and vox
Post by: dusty on December 30, 2006, 01:58:30 AM

vox will not work when set to my throttle buttons?  Works fine when I push T or f12.  Throttle buttons break squelch,  just no voice when I speak...only background noise.  Any ideas?

Title: Re: ch products and vox
Post by: DAVENRINO on December 30, 2006, 02:19:35 AM

Quote

Originally posted by dusty
vox will not work when set to my throttle buttons?  Works fine when I push T or f12.  Throttle buttons break squelch,  just no voice when I speak...only background noise.  Any ideas?

Nope, my vox transmits have always been set to Throttle index and middle finger buttons with no problems on 3 different puters.  I have never used CH CM software with AH.

Title: Re: ch products and vox
Post by: Balsy on December 30, 2006, 07:07:09 AM

Quote

Originally posted by dusty
vox will not work when set to my throttle buttons?  Works fine when I push T or f12.  Throttle buttons break squelch,  just no voice when I speak...only background noise.  Any ideas?

Vox set to my throttle buttons also, no problems.

Check your mappings in CH Control center and make sure you have them mapped to keys T and F12.

Balsy

Title: ch products and vox
Post by: Rolex on December 30, 2006, 07:40:36 AM

An alternate option is to not even use CH Manager software. You can map everything directly. Aces High is very CH friendly.

Title: ch products and vox
Post by: doc1kelley on December 30, 2006, 09:37:46 AM

Quote

Originally posted by Rolex
An alternate option is to not even use CH Manager software. You can map everything directly. Aces High is very CH friendly.

Absolutely, I have CH hotas gear and everything is programmed via Aces High and why add the overhead of CH's archaic program manager?  BTW... My vox is also programmed to buttons on my throttle.

All the Best...
Jay
awDoc1