Aces High Bulletin Board

Help and Support Forums => Technical Support => Topic started by: Sancho on September 16, 2000, 03:50:00 AM

Title: can't get rw to work
Post by: Sancho on September 16, 2000, 03:50:00 AM

Ever since 1.04 it seems, I can't get RW to work with AH the way it is supposed to.  I have 'enable roger wilco' and 'enable auto start' checked, but RW fails to start when AH starts.  If I manually start RW, AH will not automatically tune my RW for me.  The only way I'm able to use RW now is to punch in IP addresses.  (http://bbs.hitechcreations.com/smf/Smileys/default/frown.gif)

Using RW Mk Ic.  Worked fine for me before.  Still works fine for my squaddies.

Title: can't get rw to work
Post by: Maverick on September 17, 2000, 11:43:00 PM

Sancho,

Couple buddies of mine said they had to erase RW then reinstall it. I haven't had to go that far yet, but often have to set the freq in AH a few times before it finally takes.

Mav

Title: can't get rw to work
Post by: Sancho on September 18, 2000, 07:06:00 PM

yep, that did it

Title: can't get rw to work
Post by: WpnX on October 07, 2000, 10:23:00 AM

I'm having the exact same problem as Sancho, RW worked fine prior to 1.04 but now I have to manually start RW and enter RW channel IP address to get it to work. I have RW enabled in setup and am using RW Mk1c also. Tried reinstalling AH, but no luck.
Wpn-x-